Tailstock Draw Bar- ⅜-16

With our Tailstock Draw Bar, you can drill with increased safety on your lathe. No more holding the chuck and hoping that it doesn’t come out. This will allow you to drill completely through a blank by advancing and retracting the tail stock's quill while drilling, improving safety. This tool required a threaded hole in the Morse taper of your chuck. 

*NOTE: Drilling on a lathe is dangerous! 

Nothing can make drilling on a lathe completely safe. Use at your own risk. Speakeasy assumes no responsibility. 

Contains: 12” 3/8-16 threaded draw bar w/knob, adjustable stop nut, thrust bearing with washers, and spring