$32.00
With our Tailstock Draw Bar, you can drill with increased safety on your lathe. No more holding the chuck and hoping that it doesn’t come out. This will allow you to drill completely through a blank by advancing and retracting the quill of the tail stock while drilling, which improves safety. This tool required a threaded hole in the Morse taper of your chuck.
*NOTE: Drilling on a lathe is dangerous!
Nothing can make drilling on a lathe completely safe. Use at your own risk. Speakeasy assumes no responsibility.
Contains: 12” long 1/4-20 threaded draw bar w/knob, adjustable stop nut, thrust bearing with washers, and spring
10 in stock
Ohio
Akron, OH
Armenia, OH
Cincinnati, OH
Cleveland, OH
Columbus, OH
Little Hocking, OH
Porterfield, OH
Toledo, OH
Torch, OH
And surrounding areas
West Virginia
Blennerhassett, WV
Crystal Spring Lake, WV
Fairview Acres, WV
New England, WV
Oak Acres, WV
Scott, WV
Tallmansville, WV
Walkers Crossing, WV
Washington Gardens, WV
Washington, WV
And surrounding areas
Kentucky
Covington, KY
Edgewood, KY
Erlanger, KY
Fayette, KY
Florence, KY
Independence, KY
Lexington, KY
Louisville, KY
And surrounding areas
Little Hocking, OH 45742
Phone: (740) 236-3462
Phone: (304) 488-8197
Email: speakeasypenz@gmail.com